Mounting | Assembly of the product
4.2.1
Mounting on Single-Pos stand
You can fasten the Single-Pos stand to the product at a 20° angle.
Use the provided M4 x 8 ISO 14581 countersunk head screws to fasten the
stand to the upper threaded holes on the rear panel
Comply with the permissible tightening torque of 2.6 Nm
Fasten the stand with two suitable screws from above to a supporting surface
or
Attach self-adhesive rubber pads to the underside of the stand
Route the cable from behind through the opening of the stand and then
through the lateral openings to the connections
Figure 2: Product mounted on Single-Pos
stand
Figure 3: Cable routing on Single-Pos
stand
"Product dimensions with Single-Pos stand", Page 231
4
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020
37
Summary of Contents for GAGE-CHEK 2000 Series
