HEIDELBERG Suprasetter A52, Installation Manual

Page: 15 / 86

Safety
Suprasetter A52/A75 – Installation 13
Laser Standards and Regulations
The Suprasetter complies with the applicable safety regulations. It is manufactured in accordance
with the German Accident Prevention Regulations (BGV B2) and the EN 60825-1, IEC 60825-1 ("Radi-
ation safety of laser equipment") and 21 CFR 1040 (USA) standards.
Service and Maintenance
Service work may be performed solely by persons authorized by Heidelberg to do so. When perform-
ing the work described in the operating instructions and service manual, the service personnel must
adhere to the described work sequence under any circumstances. Protection from invisible laser radi-
ation is ensured by covers or safety loops. Never bypass the laser safety loop!
Upon completion of the repair, the functionality of the safety circuits must be checked. During
reassembly, the protective covers must be checked for completeness. Make sure that these
covers do not show any cracks or other damages.
Note: When the safety switches are open, only the safety loop for the motive movement of
the optics head can be bridged by the key switch. The laser safety loop is not bridged as this
is not necessary.
Laser Safety Goggles
Laser safety goggles do not have to be worn as this is not necessary. Laser adjustments are not to be
made on the Suprasetter as the modules are adjusted at the factory and are to be used without any
additional adjusting.
WARNING
Risk of injury from laser radiation
You may be exposed to dangerous radiation by the invisible high-power laser
beams if you use operating or adjustment equipment other than those mentioned
in this document or if you follow other working procedures.
Keep exactly to the described procedures.
WARNING
Caution: Remote Control
If Remote Control is run when the key-operated switch is actuated, make sure to
follow the information about
Heidelberg Remote Service, page 23 .
i
i