Heicko ERSDC1038-02-BI, Installation And User Manual

Page: 25 / 30

-25-
HRSDC-ERSDC-BI_10.01_EN
6.7 Setup / Delete intermediate stop function
Move to your
desired position
P2
x1 x1 x2
Press „Stop“
for 1 second Press „Stop“
for 1 second
Press P2
for 1 second
Press „Stop“
for 1 second
Important! - To set the intermediate stop function, the limit positions must be already set.
To get to the intermediate position
please press the "Stop" button for
2 seconds.
If the motor is using the step
function , after pressing the „Stop“
button for 2 seconds the hanging
will move (regardless of the current
position) to the lower limit position
first and then to the set
intermediate position.
The intermediate position can also be deleted using the same procedure (motor confirms 1x each).
x1
x1 x3
6.8 Add an emitter (Copy from emitter A to emitter B) - 3 options
Press P2
for 1 second
P2
Press P2
for 1 second
P2
Press P2
for 1 second
P2
A A B
x1 x1 x2
Option 1
Press P2
for 1 second
P2
Press P2
for 1 second
P2
Press „Stop“
for 1 second
A A B
x1 x1 x2
Option 2
By the same procedure
the added emitter can also be
deleted.
Press P1
for 2 seconds
x1 x2
Option 3
Press „Stop“
for 1 second
B
By the same procedure
the added emitter can also be
deleted.
x1
x1
x3
x1
x1
x3
x3 x1
0
1
6.9 Enable / Disable step function
Press either the "Up" or "Down" button for a short
movement (release within 2 seconds), press one of
the buttons for more than 2 seconds and the motor
will start to run continuously.
Press „Up“ and „Down“
simultaneously for 5
seconds
+
x1
Press „Stop“
for 1 second
= Step function enabled
= Step function disabled
(continuos mode active)
x1 x1
x2
x3
6.10 Disable radio communication
When the radio link is disabled, previously set motor functions as well as the emitter codes are retained and only the radio reception is disabled.
This prevents undesired settings on other motors.
x2
Briefly press P1 to
enable the radio reception.
Press P1
for 6 seconds
0
1
x2