01-03
21
34617 Rev D
NANOV TOP DV GAS APPLIANCE INSTALLATION INSTRUCTIONS
G. FINISHING
H. APPLIANCE PREPARATION
Figure 40
Finishing Materials
WARNING!
Grilles on this appliance cannot, in any way, be
covered as it may create a fire hazard.
1. COMBUSTIBLE FINISHING MATERIAL
Material made of or surfaced with wood, com-
pressed paper, plant fibers, plastics, or any material
capable of igniting and burning, whether flame
proofed or not, plastered or unplastered (this
includes drywall).
2. NONCOMBUSTIBLE FINISHING
MATERIAL
Material which will not ignite and burn. Such materi-
als are those consisting entirely of steel, iron, brick,
tile, concrete, slate, glass or plasters, or combina-
tion thereof, or have a UL Fire rating of zero.
3. HIGH TEMPERATURE SEALANT
MATERIAL
Sealants that will withstand high temperatures;
General Electric RTV103 (Black), or equivalent.
Rutland, Inc. Appliance Mortar #63, or equivalent.
A high temperature sealant, 1/8 inch wide bead
minimum, must be used to close off gaps between
the appliance and facing to prevent cold air leaks.
See Figure 40.
1. ATTACHING THE HOOD
The hood is to be located above the glass panel.
The hood must be attached or a fire hazard may
result.
Locate the four screws just inside the upper
section of the appliance. Position the hood and slide
into position. Tighten the four screws. See Figure 41.
2. UPPER GRILLE PANEL REMOVAL
Grasp the upper grille panel and remove the rubber
pins holding the grille. See Figure 42.
3. CONTROL ACCESS PANEL REMOVAL
Release the spring pin on the right hand side of the
control access panel. See Figure 43.
4. GLASS AND SCREEN REMOVAL
See page 27 of this manual.
Figure 42 - Upper Grille Panel Removal
Figure 41 - Installing the Hood
Figure 43 - Control Access Panel Removal
All manuals and user guides at all-guides.com
all-guides.com
