Heath Heathkit SB-104A, Manual

Page: 191 / 204

C E
EE2SEE
Page 1-189
I £ N I H £ C A 1 I O N
=
S 1 R I
/
//
ti
tv
a%.j
=
'\I'
Detail 12-32K
W H E P L A S T I C
D I F F J S E R S T R I P
'
R1 to Detail 12-32K for the next two steps.
( ) Place the identification strip into opening EF so the
/letters
will appear correctly when viewed from the
front panel.
Place the white plastic diffuser strip into opening EF.
Remove any covering from the clear plastic
identification strip.
( ) Start at the center of your call and remove the letters,
one at a time, from the call letter label sheet and press
the adhesive side into position on the clear plastic
identification strip. Tweezers may help you to
position the letters properly. The edges of the labels
must overlap each other slightly to prevent light
leakage, so proper alignment of the labels on the strip
is important.
B L A C K
s
O V E R L A P S
C L E A R
I D E N T I F I C A T I O N
S T R I P
( ) After you have your call letters centered on the
identification strip, fill the remaining clear spaces at
each end of your call with black squares. Remember
to overlap the edges.
Detail 12-32J
C E N T E R
L I N E
l
'
w9VW
w8ABC
I
WA8XYZ
I
I
Refer to Detail 12-32J and install the meter at M.
it the meter face into the panel opening. Then
position the meter clamp from EC against the meter
case and tighten the hex spacer.
NOTES:
2.
The letters of your call will be centered on the iden­
tification strip. You will start at the center of the strip
and work first to the right end of your call and then to
the left. First, determine the center line of your call:
1. If you wish to use the call letter display, this note and
the following steps tell you how to mount your call
letters on a clear plastic identification strip which will
be mounted in a panel opening.
Inspect the meter terminals carefully. If you find a
l 'all wire connecting the two terminals, remove and
scard it.
{ Prte a 2" gray wire.
( ./connect one end of the gray wire to the"-" terminal
of the meter (S-1). The other end will be connected
later.