Heath Heathkit SB-104A, Manual

Page: 166 / 204

Page 1-164
E E
SEE
Refer t Pictorial 12-17 (Illustration Booklet, Page 9) for
the f I wing steps.
BO#4. Connect harness wires as follows:
B O #1 , Connect harness wires as follows:
h te-brown-brown to D8 (S-1/2).
hite-violet-violet to D12 (S-1/2).
Yellow to D14 (S-1/2).
White-red wire to terminal strip BP lug 4 (NS).
ellow to G15 (S-1/2).
hite-blue to G18 (S-1).
Gray to G21 (S-1).
R:f}_t Pictorial 12-18 for the following steps.
B,; Connect harness wires as follows:
( ) White-green to K6 (S-1).
White to K4 (S-1).
B O # 1 .p o n n ec t harness wires as follows:
( J-
Vhite-brown-brown to G10 (S-1).
Black to B10 (S-1).
Blue to B8 (S-1).
Red to B1 (S-1/2).
White-yellow to A8 (S-1).
' '
White-orange to A5 (S-1).
BO 9. Connect harness wires as follows:
(
) Black to A3 (S-1) .
White-orange to Al (S-1).
10. Connect harness wires as follows:
White-red to A18 (S-1).
White-yellow to A20 (S-1 ).
White-violet-violet to A22 (S-1 ).
White-violet to A24 (S-1 ).
B
6.
Connect
harness wires as follows:
Brown to B23 (NS).
Brown to B23 (S-2).
Long white to B24 (S-1).
#5. Connect harness wires as follows:
Brown to C18 (S-1/2).
White-brown-brown to C16 (S-1/2).
Blue to C20 (S-1/2).
( Gray to C22 (S-1/2).
\
( , Short white-green to C6 (S-1).
( � White-orange to C4(S-1).
NOTE: When you connect harness wires to the relay in the
following steps, push the wire through the lug opening, then
up and over the top of the lug and down along the flat side.
Shorten the bare end of the wire as necessary to keep it
from touching another lug. See Detail 12-18A.
Detail 12-18A