Heath Heathkit SB-104A, Manual

Page: 155 / 204

Page 1-153
( �.. from terminal E3 (S-1) to terminal E11
GEJLth
-1/2" red from terminal E20 (S-1) to terminal F17
S-1).
7 orange to terminal F19 (S-1 ). The other end will be
connected later.
Detail 12-6A
C I R C U I T B O A R D
#85-1930-1
#6 x5/8"
€
%
co
l]seer
A
S C R E W
The center conductor of the coaxial cable coming
from A to terminal G4 (S-1). Place a small ferrite bead
on the shield wire. Then connect the shield wire to
terminal G5 ($-1/2).
Refer to Detail 12-6A and install the VFO filter circuit
board, #85-1930-1, at AK and AM. Use #6 x 5/8"
hex head sheet metal screws and 1/8" long spacers.
Co�nect the wires coming from the circuit board as follows:
(), R move an additional 1/4" (total 1/2") from the gray
ire. Then place a small ferrite bead on the wire and
onnect the wire to terminal D4 (S-1).
Red wire to terminal D1 (S-1/3).
6" red
3-3/4" gray
7"
orange
14" gray
terminal F3 (S-1/2) to terminal F17
the prepared wires as follows:
terminal E 1 1 (S-1/3) to terminal
3/4" red to terminal F3 (S-1), Push the other end of
e wire through grommet BA. It will be connected
3-3/4 gray from terminal G15 (S-1) to terminal G22
(s-1).
4-1/4" gray
3-1/2"
red
1-3/4" red
14 gray to terminal F7 (S-1/2). Push the other end
through grommet BA as far as possible.
1-3/4" red from terminal F17 (S-1/2) to terminal G14
(S-1).
Ct: Connect the positive
(+)
lead of a 10
F
electrolytic capacitor to C7 (S-1/2). Connect the other
lead to the
upper
hole of solder lug AH (NS).
C13: Connect a .001
f
disc capacitor from terminal
F13
(NS) to
terminal F 1 5 (NS).
) 11·5;�" gray from terminal E13 (S-1) to terminal E23
( gray from terminal E7 (S-1) to terminal E14 (S-1),
( 'epare the following solid wires: