Heath Heathkit SB-104A, Manual

Page: 129 / 204

CESEE
Page 1-127
NOTE:
PICTORIAL 11-6
t the gray wire coming from LD to hole T
0 0 0
D
«=a
o l 5
5 OJ
4
t u
M
0
0
�
( ° °
0
Refer to Pictorial 11-6 for the following steps.
Detail 11-5E
Tr
• In the following steps, circuit board holes are
identified on the component side of the board. When
you connect a wire in these steps, push the wire end
into the hole from the foil side and solder the wire to
the foil. Then cut any excess wire ends from the top
of the board. Trim the wires to length, if necessary.
• Each wire to be soldered in this Pictorial is bent over
the sharp edge of a circuit board hole. Before you
solder each lead, be sure there is a small amount of
clearance between the wire insulation and the edge of
the/ hole so the soldering heat will not soften the
�f._lation and possibly cause a short circuit.
(, i
/nnect the red wire coming from LC to hole
Z
(S-1 ).
( ) Connect the gray wire coming from LC to hole R
(s-1).
/ Connect the red wire coming from LD to hole S {S-1 ).
( ) onnect the red wire coming from LJ to hole M (S-1).
{ '2.feonnect the gray wire coming from LK to hole N
'(S1).
,( Tw· ; the remaining two wires coming from LK and
L together. Connect the red wire to F (S1)and the
aywireto E (S-1).
Refer to the Pictorial and connect the gray wire
coming from LN to hole C (S-1) and the red wire to
hole 8 (S1).
( /'\) Connect the gray wire coming from LP to hole G (S-1)
\ and the red wire to hole D (S-1).
(( 1
Connect the gray wire coming from LR to hole H
(S-1) and the red wire to hole W (S-1 ).
Connect the gray wire coming from LS to hole X (S-1)
and the red wire to hole Y (S-1).