17
Glass Assembly
Care and
Installation
The Heat-N-Glo fireplaces have various glass assem-
bly designs. Some of the glass assembly designs in-
corporate one or more of the following basic designs.
Choose the basic design used on your fireplace from
the following diagrams and follow the accompanying
instructions.
The initial burn of the gas fireplace should be for ap-
proximately 3 to 4 hours. During this time there may be a
slight odor and also a light film may accumulate on the
inside of the glass. This odor and film are simply part of
the paint, logs and ember materials curing process.
Following this initial burn, turn off the fireplace and allow
the glass to cool completely. Remove the glass using
the appropriate removal instructions. Clean the glass
with any common household glass cleaner and soft
cloth. Cleaning the glass after the initial 3 to 4 hour burn
will prevent the film from becoming baked on to the glass.
After this initial cleaning it should only be necessary to
clean the glass occasionally as required.
NEVER SCRAPE OR RUB GLASS WITH ANY ABRA-
SIVE MATERIALS OR CLEANERS.
Figure 11. Glass Assembly
Remove any louvers, doors or decorative panels to ac-
cess the glass latches. Pull the glass latches out of the
groove on the glass frame by pulling them towards you.
After replacement, reinstall glass latches, making sure
the latch is seated firmly in the glass frame slot. Rein-
stall any trim door or louvers.
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
PULL TO
UNLATCH
GLASS LATCH