13
When you light your fireplace for the first time, you may notice:
This gas appliance produces heat which does have an associated odor or
smell. If you feel this odor is excessive it may require the initial 3-4 hour
continuous burn on high followed by a second baurn of up to 12 hours to fully
drive off any odor from paint and lubricants used in the manufacturing pro-
cess. (See Cleaning Glass Assembly section for further information.) Addi-
tionally, for the first few minutes after each lighting, vapor may condense and
fog the glass and flames may be blue. After a few minutes this moisture will
disappear and within 15-30 minutes the flames should become yellow.
Noise caused by metal expanding and contracting as it heats up and cools
down, similar to the sound produced by a furnace or heating duct. This noise
does not affect the operation or longevity of your fireplace.
A Red Light. The
DSI
Module of this fireplace is equipped with a
Red
indicator
light which functions as follows:
Red Light
Fault Condition
1. Slow Flash = Normal operation, no call for heat.
2. Fast Flash = Normal operation, call for heat.
3. Two Flashes = 5 minute trial lockout, on/off reset required.
4. Steady On = Hard lockout control, failure.
Do not attempt to service or repair the equipment yourself - Turn the
ON/OFF switch to "OFF" and call a qualified service technician.
1.
STOP!
Read the safety informa-
tion on page 9 first!
2. Turn off all electric power to the
appliance.
3. This appliance is equipped with an
ignition device which automati-
cally lights the burner. Do not try
to light the burner by hand.
3. Turn off all electric power to the
appliance if service is to be per-
formed.
1. Open the lower grille.
2. Turn ON/OFF switch to "OFF".
4. WAIT AT LEAST FIVE (5) MINUTES TO
CLEAR OUT ANY GAS. If you have un-
successfully tried to light the fireplace, wait
longer, especially if you are using LP gas.
Then smell for gas, including near the
floor. If you then smell gas, STOP! Fol-
low "B" in the safety information located
on the previous pages. If you don't smell
gas, go to next step.
5. Turn on all electric power to the appliance.
6. Open the lower grille.
7. Turn ON/OFF rocker switch to "ON".
8. If the appliance will not operate, turn off
the gas as instructed below and call your
service technician or gas supplier.
OPERATING INSTRUCTIONS
DSI CONTROLS
GAS
VALVE
TO TURN OFF GAS TO APPLIANCE