TitanMig Pulse 270/3500/5000 Operators Manual
Issue. A 0516
33
Special 4T
Spot Welding
End current(EndI):
as figures shown, its function is to fill the crater.
Initial current(HotI) :
as figures shown, its function is to increase the heat input when start to weld and
avoid the welding defects during the arc strike.
Burn time:
it is to adjust the effect of ball cutting when finish welding.
Spot time(Sptt):
the duration of the spot welding.
Initial time(Hott):
the duration of the initial current, it is only suitable for S2T.
End time(Endt):
the duration of the end current, it is only suitable for S2T.
Slop time(SLOP):
the switching time between two currents, such as the initial current and welding current.
Double pulse frequency (Freq):
as figures shown
The arc length of double pulse (AL2):
as figures shown, it is the High arc length value of the double pulse
MIG, The lowe arc length decided by corresponding arc in the indicator lamp I
The scope of the double pulse(Fd2) ,
as below figures shown, it is the rangeability of wire speed for
double pulse.
Summary of Contents for TitanMig Pulse 2700
