Headux TitanMig Pulse 2700, Operation Manual, Page: 25 / 72

TitanMig Pulse 270/3500/5000 Operators Manual
Issue. A 0516 21
1.8 TMP welding machine startup Settings.
Some welding parameters of TMP series welding machine could be adjusted through the startup Settings
menu, and the operation process as following
：
1) Press on key, and turn on the power switch of the machine at the same time.
2) After few seconds, it enters the Startup Settings Menu, and LED display "Preg" as Figure 3.3.1.
3) Press to choose , then the left part of the LED display the parameter name, and
right part of the LED display the parameter value.
4) Turn the left side to choose the parameter name, turn the right side to adjust the
parameter value.
5) Press , the LED will display "Finished", means the parameter has been reset and stored. Then
restart the machine and weld.
Adjustable parameters name of startup Settings as following:
1) Pre-gas flow time (PreG): Adjustable from 0-15s, the default value is 0.1s. It works for MIG, Pulse
MIG, Double Pulse MIG, TIG, Pulse TIG and Spot TIG.
2) Post-gas folw time (PosG) : Adjustable from 0-15s, the default value is 0.1s. It works for MIG, Pulse
MIG, Double Pulse MIG, TIG, Pulse TIG and Spot TIG welding processes.
3) Soft start wire feed speed (Stfd) : Adjustable from 1-22 m/min, and also can be set at automatic. It
works for MIG, Pulse MIG and Double Pulse MIG welding process.
4) Inch wire feed speed (Infd) : Adjustable from 1-22 m/min.
5) Master station MACID (NetP) : Master station MACID of Devicenet: 0-63.
6) Slave station MACID (NetS) : Slave station MACID of Devicenet: 0-63.
7) Device net baud rate (Netb) : 0-125 k, 1-250 k, 2-500 k
8) System Set 1 (Set1) : Bit0 = 1 means allow the simulation remote control, 0 means banned.
9) System Set 2 (Set2) : temporary undefined.
10) Wire feed machine coefficient (Fdp), wire feed machine constant (Fdc) : according the different
wire feed motor, setting up different coefficient. First Type, 24V, 22M/Min, 5A motor: Fdp = 400; Fdc =
426; Second Type, 24 v, 22 m, 3.5 A motor: Fdp = 371; Fdc = 400;
11) Setting up Password (Pas1, Pas2, Pas3, Pas4) : function password settings.