E Legacy Information
E.1
IOTech RS232 to GPIB interface
Early deliveries of the calibration setup included an IOTech RS232 to GPIB
convertor. Altough the software still supports this it is strongly recommended to
replace the IOTech with a USB to GPIB convertor.
l
Connect the calibrator equipment to the GPIB side of the IOTech serial to
GPIB interface.
l
Connect the serial side of the IOTech interface to a COM port on the PC
running the software.
For further details, please refer to the IOTech manual.
Figure E.1:
Connection diagram using the IOTech serial to GPIB interface
ISOBE5600
122
I2716-4.0 en
