HBK 10M0, Mounting Instructions, Page: 27 / 106

25
C5
VERSIONS AND ORDERING NUMBERS
Nominal (rated) force You can purchase force transducers with nominal (rated)
forces between 5 MN and 20 MN. The nominal (rated) force is
the force at which the sensor provides the rated output
specified on the type plate as the output signal.
No. of measuring
bridges You can purchase the force transducer with a single bride (SB),
in which case the C5 comes supplied with one measuring
bridge. The double-bridge version (DB) is optionally available.
In this case, the C5 is supplied with two electrically isolated
bridge circuits, so that two independently working bridge
amplifiers can be connected.
Bending moment
bridges You can purchase the force transducer with bending moment
bridges (WB). In this case the C5 is supplied with two bending
moment bridges, so that you can measure the effective bend­
ing moments irrespective of the other measured quantities.
Transducer
identification You can purchase the force transducer with a transducer
identification (“TEDS”). A TEDS (Transducer Electronic Data
Sheet) chip allows you to store the transducer data (rated
outputs) in a chip, which can be read by a connected
measuring device. In the double-bridge version, each
measuring bridge has a dedicated TEDS chip. For more
detailed information, refer to the operating manual.
Plug protection If you wish, we can fit plug protection, consisting of a strong
square tube, so that the plug is protected against mechanical
damage.
Electrical connection The standard version is the device plug with a bayonet
connection (PT02E 10-6P-compatible). You also have the
option of ordering a device plug with screw thread (PC02E
10-6P-compatible). If you order a force transducer in the
double-bridge version and/or with bending moment bridges, all
measuring bridges will be supplied with the same device plug.
Overloading You have the option of overloading the force transducer as
preparation for calibration.