USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
37
If VSP is selected:
Which Hayward Unique Address?
If using a VSP for your accessory
pump, you’ll be asked what is the Hayward Unique Address (HUA). If
a value is already shown in the box, advance to the next screen. If no
value is shown, selecting the box will bring you to a table showing all
detected devices. Select the proper HUA from the table and touch the
Done button. The address should now be shown in the box and you
can advance to the next screen to continue the VSP configuration.
Pump Capacity -
Set the minimum and maximum RPM of the pump.
Refer to your pump manual for more information.
Permitted User Setting -
The AQR S3 Omni will automatically cal-
culate these values based on the minimum and maximum RPM that
were previously entered. They can be changed as desired.
Speed Presets -
Set the Low Pump Speed %, Medium Pump Speed
%, and High Pump Speed %, presets. These presets will be used
when setting schedules for your pump.
Would You Like to Enable Priming?
Select whether you want the
pump to prime when turned on. This will turn the pump on at high
speed for 3 minutes to establish normal water flow every time the
pump is activated after being off for at least 30 seconds.
Accessory Wired to Relay?
Select whether the accessory requires the use of a high
voltage relay.
If Yes is selected:
Select Relay -
Touching the box will bring you to a table showing all de-
tected relays. Select the relay that is connected to the accessory and touch
the Done button. The relay should now be shown in the box and you can
advance to the next screen to continue the accessory configuration.
Does Accessory have a Valve?
Select whether the accessory requires a valve to
change position when in use.
If Yes is selected:
How Many?
Select how many valves are used for the accessory.
Where is the Valve(s) Wired?
Selecting the box will bring you to a table
showing all detected low voltage relays. Select the relay(s) that is wired to
the accessory valve(s), then advance. The valve(s) should now be shown in
the box. Advance to the next screen to continue accessory configuration.
Freeze Protection Enabled?
Freeze protection is used to protect the pool and
plumbed equipment against freeze damage during cold temperatures. If freeze pro-
tection is enabled AND the air temperature falls below the freeze threshold (refer to
pump configuration), the AQR S3 Omni will turn on the accessory pump to circulate
the water.
