USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
33
Done button. The address should now be shown in the box and you
can advance to the next screen to continue the VSP configuration.
Pump Capacity -
Set the minimum and maximum RPM of the pump.
Refer to your pump manual for more information.
Permitted User Setting -
The AQR S3 Omni will automatically cal-
culate these values based on the minimum and maximum RPM that
were previously entered. They can be changed as desired.
Speed Presets -
Set the Low Pump Speed %, Medium Pump Speed
%, and High Pump Speed %, presets. These presets will be used
when setting schedules for your pump.
Would You Like to Enable Priming?
Select whether you want the
pump to prime when turned on. This will turn the pump on at high
speed for 3 minutes to establish normal water flow every time the
pump is activated after being off for at least 30 seconds.
Does Cleaner have a Valve?
Select whether the cleaner requires a valve to change
position when in use.
If Yes is selected:
How Many?
Select how many valves are used for the cleaner.
Where is the Valve(s) Wired?
Selecting the box will bring you to a table
showing all detected low voltage relays. Select the relay(s) that is wired to
the cleaner valve(s), then advance. The valve(s) should now be shown in
the box(es). Advance to the next screen to continue cleaner configuration.
Would you like your valve(s) to cycle On and Off at a set interval?
If
you would like the cleaner valve(s) to cycle to a set interval while cleaning,
select Yes. Set the interval on the next screen.
Freeze Protection Enabled?
Freeze protection is used to protect the pool and
plumbed equipment against freeze damage during cold temperatures. If freeze pro-
tection is enabled AND the air temperature falls below the freeze threshold (refer to
pump configuration), the AQR S3 Omni will turn on the cleaner pump to circulate the
water.
How Many Water Features?
- This question is for THIS BODY OF WATER ONLY. For example:
If you have 2 water features; one for the pool Body of Water and one for the spa Body of Water,
you would answer “1” to this question.
If “1”or more is selected:
Select and Configure a Water Feature
At this screen you can add, delete and con-
figure your water features. Select the desired water feature, then touch the Advance
button. When finished configuring water features, you’ll be returned to this same
screen. Touch the Done button and advance to the next section of configuration.
Refer to the following information when configuring water features:
