USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
32
chemical supply and the feeder. If both are OK, the timeout may need to be
increased. The user must clear the alarm to resume pH dispensing.
pH Extend Enabled
- If enabled, the AQR S3 Omni will continue to run the
filter pump regardless of schedule until the pH level in the pool has reached
the setpoint.
How Many Cleaners?
- This question is for THIS BODY OF WATER ONLY. For example: If you
have 2 cleaners; one for the pool Body of Water and one for the spa Body of Water, you would
answer “1” to this question.
If “1”or more is selected:
Select and Configure a Cleaner
At this screen you can add, delete and configure
your cleaner(s). Select the desired cleaner, then touch the Advance button. When
finished configuring cleaner(s), you’ll be returned to this same screen. Touch the
Done button to advance to the next section of configuration. Refer to the following
information when configuring cleaner(s):
Type of Cleaner?
Touch the box and select the type of cleaner used. Choices are
Pressure, Suction, Robotic and In-Floor.
Name of Cleaner -
Touch the box and use the keyboard to name the cleaner.
Does Cleaner Have a Pump?
Select whether the cleaner has a dedicated pump.
If so, the AQR S3 Omni will turn this pump on when the cleaner is scheduled to run.
If Yes is selected:
What Type?
Select the type of pump used. The choices are Single Speed,
Two Speed and VSP.
If single speed or two speed pump is selected:
Which Relay is it Wired to?
If using a single speed or two speed
pump, you’ll be asked which relay(s) is wired to the pump. If a value is
already shown in the box(es), advance to the next screen. If no value
is shown, selecting the box will bring you to a table showing all de-
tected relays. Select the proper relay(s) from the table and touch the
Done button. The relay should now be shown in the box(es) and you
can advance to the next screen to continue the pump configuration.
Would You Like to Enable Priming?
Select whether you want the
pump to prime when turned on. This will turn the pump on at high
speed for 3 minutes to establish normal water flow every time the
pump is activated after being off for at least 30 seconds. This option
only appears if the pump is configured as a 2-speed pump.
If VSP is selected:
Which Hayward Unique Address?
If using a VSP for your cleaner
pump, you’ll be asked what is the Hayward Unique Address (HUA). If
a value is already shown in the box, advance to the next screen. If no
value is shown, selecting the box will bring you to a table showing all
detected devices. Select the proper HUA from the table and touch the
