To attach using the removable wall-mount adhesive strips:
s
Clean the surface of the desired location of the Controller
with isopropyl rubbing alcohol, wipe gently with a soft cloth
and let dry. DO NOT USE household cleaners. (see Figure 1.1)
s
Separate strips (if still connected) at the perforation.
s
Peel the liner from the back of one of the strips and attach it
vertically to the middle of the Controller with the release-tab
pointed upward toward the antennas. (see Figure 1.2a)
s
Connect another strip to the strip on the Controller by
pressing the fasteners of both strips firmly together until
they snap. The release-tab on the other strip should point
downward away from the antennas - the opposite direction
of the release-tab of the strip on the Controller (see Figure 1.2b).
s
Peel the liner from the back of the other strip and attach it
to the wall with the release-tab facing downward toward the
floor and the Controller antennas facing upward toward the
ceiling. (see Figure 1.3)
To remove the adhesive strips:
s
Pull the Controller gently from the wall by disconnecting
the fasteners. DO NOT pull the strips off the Controller or
the wall.
s
Start with the strip on the wall. Press one hand on the end of
the strip opposite of the release-tab and use your other hand
to pull the release-tab slowly straight down against the wall
stretching it at least 12 inches until the strip releases. Repeat
for the strip attached to the Controller (see Figures 1.4a & b).
10
Setting Up the Controller
3.
Plug the Controller (DC power connection located on
the bottom of the Controller) into a nearby standard
electrical
outlet.
4.
”Havahart Wireless Fence.” will display (see Screen 1.1)
5.
Press “Enter”
Screen 1.1
Figure 1.1
Figure 1.2a
Figure 1.3
Havahart
®
Radial-Shape Wireless Dog Fence
1-800-800-1819, Option 1
NOTE:
When the unit is first activated, you may receive a
“POWER FAILURE DETECTED!!!” warning. Disregard this
message and Press ENTER.
Figure 1.4a
NOTE:
The removable wall-mount adhesive strips are not
recommended for wallpaper. Apply to surfaces above 50
˚
F .
Adhesive could soften and lose adhesion above 105
˚
F.
Figure 1.2b
Figure 1.4b
