11
Setting Up the Collar
2
Setting Up the Collar
Installing the Radial-Shape Wireless Dog Fence
Havahart
®
Radial-Shape Wireless Dog Fence
www.havahartwireless.com
The Collar should not be placed on your
dog until after you have successfully
installed it on the system.
Install one Collar at a time. The system
allows you to activate up to 2 Collars.
The default correction level of the Collar
is set to Tone Only, which you need to use
to set up your fence boundary.
!
IMPORTANT MESSAGE
Figure 1.
Battery Installation
CR123A 3V
+
-
Screen 1.3
Screen 1.2
Screen 1.4
Installing a Battery:
1.
Make sure a battery is fully charged before installing it in the
Collar (see Recharging a Battery). Turn the battery cap on the
Collar counterclockwise about 1/4 turn and pull it out. With the
positive side facing outward, install one RCR123A battery into
the Collar. (see Figure 1.5) Replace the battery cap and turn it
clockwise to lock it in place.
2.
A green light should flash every 5 seconds. If it does not, check
the direction that the battery was installed --- positive side
should be facing outward.
NOTE :
The Collar is always “on” when a good battery is installed. However,
the Collar may be awake or asleep. Integrated Motion Sensor Technology
allows the Collar to conserve battery life when appropriate by putting the
Collar to sleep. The light on the Collar will not flash when the Collar is
asleep. Movement, such as gently shaking the Collar, will awaken it and
the green light will flash. A red light will flash to indicate that the battery
needs to be recharged. The Controller will also produce an auditory tone
to alert you that the battery is low.
Checking Battery Status:
1.
Select “Display Options” (see Screen 1.2)
2.
Select “Show Collar Monitor” (see Screen 1.3)
Battery
Status Collar is:
NA
Asleep to conserve battery life
OK
Battery life is shown as a percentage (see screen 1.4). When a
battery needs to be recharged, a Low Battery Alert will
appear (see screen 1.5).
LOW
Awake, but battery needs to be recharged soon
Screen 1.5