Haulotte Group H21TX, Operator'S Manual

Page: 61 / 104

A
B
C
D
E
F
G
H
I
61 2420331900 E06.14 EN
Telescopic machines, 21 - 25 m
E
- Driving
3 - Operation
N.B. -:-The functions are described for the entire range. Refer to the machine model to identify the
controls and functions indicators.
N.B. -:-Using unsuitable fuel may cause diminished performance, difficulties starting, excessive pollution
and premature wear. To establish the type of fuel suitable for the engine fitted on your HAULOTTE®
machine, please refer to the engine manufacturer's manual. The engine may not be covered by the
warranty in case of damage caused by using unsuitable fuel.
3.1 - TEST PROCEDURE
3.1.1 - Emergency stop button operation
Ground control box emergency stop button
Platform control box emergency stop button
3.1.2 - Tilt sensor switch operation
1. Pull the emergency stop push-buttons on the upper and lower control boxes (15, 46).
2. Switch on the machine from the lower control box (72, 230). All of the ground control box
indicators light up and a sound signal (beep) is emitted.
3. Start the machine (22).
4. Lift the boom or jib above horizontal.
5. Locate the tilt sensor next to the ground control box.
6. Manually tilt and maintain the tilt sensor towards the front for a few seconds
(
Section C 2-Main components) :
7. The audible beep sounds.
8. For machines fitted with : The slope sensor prevents lifting and driving movements.
Find all the function indicators and controls in Section C 5 - Control boxes
Step Action
1 Pull the emergency stop buttons( 15, 46 ).
2
Turn the key on the control box activation selector switch ( 72 ) to the right to energize the
ground control box. The indicators light up.
3 Push the emergency stop button ( 15 ). The indicators go out.
Step Action
1 Pull the emergency stop buttons( 15, 46 ).
2
Turn the key on the control box activation selector switch ( 72 ) to the left to energize the
platform control box. The indicators light up.
3 Push the emergency stop button ( 46 ). The indicators go out.
Machine unfolded, the slope sensor gives an audible signal telling the operator that the machine should
not be deployed. In this case, fully lower the platform and reposition the machine on level ground before
raising the platform again.