Hatteland HT C02HI STC series, User Manual

Page: 32 / 102

32
IND100210-36
General Installation Recommendations
Installation
Replacing Internal CMOS Battery
Note: Areas of interest are marked in this section with arrows in RED color. Please disconnect ALL cables from the
computer unit before proceeding! Procedure applies for HT C02H, HT C02HI and HM C02HK models.
NOTE: All BIOS settings, Date and Time will be lost if battery is removed from motherboard. If Factory Default BIOS
settings was changed after unit was received from factory, please write down changes (if known) before doing this
procedure. Operating System installed will not be affected by a battery replacement. After battery was replaced and
unit powered, check BIOS settings and choose to load Factory Default Settings, change time and date. BIOS
Settings and its adjustment are outside the scope of this chapter in User Manual. Consult your experienced technician
or contact our service / support channels worldwide for further assistance if unit does not operate as intended.
1: Unscrew 3 screws from top of cabinet.
Use a Pozidriv #2 screwdriver.
2: Unscrew 3 thumb screws in rear of cabinet. Turn anti-
clockwise using your fingers or flat screwdriver (if tight).
3: Push cover gently down while pushing forward approx
10mm [0.39”] away from the front.
4: Lift the cover up with both hands.