Hatteland HT C02HI STC series, User Manual

Page: 21 / 102

21
IND100210-29
General Installation Recommendations
Installation
Installing PCI / PCIe Card / Rework PCI Bracket Options - Notice
All factory options are done in-house by our production facility prior to delivery. If you however need to install your
own PCI/PCIe cards later and any of the PCI Bracket Options are already pre-installed, please review:
“Physical Connections/ Added functionality through 4 x PCI Sized Metal Brackets” chapter later in this manual.
As this is just a pre-installation notice, please review also the 2 next following pages regarding PCI/PCIe card
installation. Procedure applies for HT C02H, HT C02HI and HM C02HK models.
Note: Areas of interest are marked in this section with RED color. Please disconnect ALL cables from the computer
unit before proceeding!
1: Identify if either of the PCI Bracket Options (PS/2
and AMP) are present (as indicated). If yes, proceeed
to step 2,3,4. If no, please proceed to next page in this
manual.
2: Observe the tie wrap and positioning of cables.
You may have to cut the tie-wrap that holds the cable to
the inner chassis, in order to insert the new PCI/PCIe card
and fit the cable again.
3: Either move the PCI Bracket Option into any of the
other free slots, or make sure the original cables are
routed under the PCI/PCIe card when you install the
new PCI/PCIe card (depending on which slot you have
to use).
4: After installing the PCI/PCIe card, observe that the PCI
Bracket Options cables are not damaged, loose or are
subject for getting damaged after long use. Notice also
some PCI/PCIe card components may get hot. If possible,
add a tie wrap to secure the cables further to keep clear of
potentional heat.