WICKET FUNCTION...................................................................................................................14
OPEN ONLY FUNCTION.............................................................................................................16
PHOTO CLOSE FUNCTION........................................................................................................17
LIMIT SWITCH TYPE..................................................................................................................17
DELETING ALL TRANSMITTERS.............................................................................................17
PROGRAMMING OF TRANSMITTERS....................................................................................18
TECHNICAL SPECIFICATION.............................................................................................................................19
DECLARATION OF CONFORMITY.....................................................................................................................19
........................................................................................................................................................................19
WARRANTY CONDITIONS................................................................................................................................20
1. DESCRIPTION AND PRINCIPLE OF OPERATION OF THE DRIVE
The HATO 400Y drive is designed for sliding gates. It has been equipped with an auto-reverse function,
infrared sensors, partial opening (pedestrian crossing), mechanical unlocking enabling manual opening in
the event of failure of the drive controller. The device consists of a single-phase motor and a worm gear. The
main motor shaft rotates the worm, driving the worm gear and pinion, moving the rack attached to the
gate, thereby causing it to shift. In the event of an electrical failure, you can release the motor lock and push
the gate by hand. The device has a temperature sensor installed, which automatically turns off the engine at
120 ° C and turns it on when the temperature drops to 85 ° C +/- 5 ° C.
The applied system of rolling coding of Microchip remote controls makes the system unavailable to an
unauthorized person.
2. IMPORTANT SAFETY INSTRUCTIONS
The drive and the sliding gate should be installed in accordance with the instructions presented in Fig. 1. It
is recommended to install stops at both ends of the gate to prevent it from falling out of the rails. The rails
must be installed horizontally. To ensure adequate stability, the drive foundation should be made of
concrete. Electric wires must be secured with a suitable installation pipe. If a hand switch is installed, use
two pipes: one for the power cord and the other for the low voltage wire (to the button). The method of
fastening the drive is shown in Fig. 2, the drive can be attached to the so prepared mounting base. Fix the
rack to the gate with screws and adjust it so that it fits exactly with the pinion. The distance between the rail
and the wheel should be approx. 0.5-1 mm.
