running in a given direction, do not press the
SBS
button and wait until the gate reaches its end
position.
ATTENTION!
After each motor power adjustment on the
VR1
potentiometer, the motor operation programming
procedure must be repeated.
ENGINE OPERATION PROGRAMMING
For work with encoder support, adjust the
overload with the potentiometer
VR2
, in
accordance with the applicable standards.
RESTORING DEFAULT SETTINGS - 60s operation without encoder and without
deceleration
Hold down the
SETUP
button.
The
LED
will turn on and then turn off.
Release the
SETUP
button.
If the gate is in the fully closed position, the
LED
will flash quickly, and if it is in another position, it
will flash slowly.
CL
?
Hold down the
SETUP
button.
The
LED
will blink 3 times.
Release the
SETUP
button. The controller will
return to normal operation.
WICKET FUNCTION
It allows the door to be partially opened to the programmed width using the remote controls assigned
to this function. The opening width can be programmed. With the
PHOTO CLOSE
function active, when
an obstacle appears in the opening of the photocells, the gate will stop. It can be closed by pressing
the manual control button or the remote-control transmitter. In conjunction with the
AUTO
-
CLOSE
and
PHOTO CLOSE
functions enabled during opening, when an object appears in the light of the photocells,
the gate will stop, and when the object is removed, it will automatically close after
5 seconds.
ADJUSTING THE WIDTH OF THE GATE OPENING
Hold down the
SETUP
button.
The
LED
will turn on and then turn off.
Release the
SETUP
button.