Instructions for Gate Opener
Single Button Entry Transmitter
FCC Regulation:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If you already have a transmitter that operates
your gate and are simply adding an additional
transmitter, set the DIP switches in the new
transmitter to match the DIP switches in
your original transmitter, reassemble the
transmitters and you are done.
If you are replacing a lost transmitter and you know or have your original transmitter’s DIP switch
setting written down, set the new transmitter DIP switches to that setting and it is ready to activate
your gate opener.
If you don’t know the DIP switch setting from your original transmitter,
you will need to select a new setting.
Personalize your Transmitter Setting
There are nine (9) DIP switches, each of which can be placed in
three different positions (+,0,-). DO NOT set all switches in the same
position, such as all +, all -, or all zeros.
Program New Transmitter Setting to Gate Opener’s Memory
Some gate openers are programmed with a LEARN REMOTE or
LEARN TRANSMITTER button and some with the ON/OFF switch.
Refer to your Gate Opener’s Installation Manual for instructions on
how to program the transmitter to your gate opener.
NOTE: If the red light on the transmitter is dim or flickers when the
transmitter button is pushed, the transmitter battery may be weak.
Replace when necessary with a A23S 12 Volt battery.
ORIGINAL
TRANSMITTER
NEW
TRANSMITTER
1 2 3 4 5 6 7 8 9
Instructions for adding additional entry transmitter(s)
Instructions for replacing a lost entry transmitter
You can have as many transmitters as you want for family and guests to open your gate.
The DIP switches in all the transmitters for a particular gate opener must be set the same.
1 2 3 4 5 6 7 8 9
1 2 3 4
ON
STATUS
LEARN RMT
LEARN
MAST LIMIT
S3
S2
OFF
SOFT START OFF
WARNING OFF
OPEN PULL
SLV OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN
MAX
AUTO CLOSE TIME
STALL FORCE
ON/OFF
+
or
IMPORTANT:
I
f you change the DIP switches in the
original transmitter refer to
Program
New Transmitter Setting to Gate
Opener’s Memory section below.
Open transmitter to
access DIP switches
Reassemble the
transmitter when finished
