Hasler HJ500P, Operating Manual, Page: 13 / 40

Section 2 – Installing The HJ500P
HJ500P
Hasler
®, Inc. 03/2004 Page-5
Before using the printer the following must be done:
•
Choose a location for the Printer
•
Plug in the printer and connect it to the computer
•
Install the Inkjet Cartridges
•
Set up the feed on the printer
•
Install the HJ500P Printer Driver and BIOS Manager software on the computer
Choose a Location
The HJ500P should be placed on a sturdy worktable or cabinet at least 12 inches from any walls. Protect the
HJ500P from excessive heat, dust, and moisture – avoid placing it in direct sunlight.
Connecting the HJ500P
Plugging in the Printer
Make sure that the main power switch of the HJ500P Printer
is in the OFF position.
1. Connect one end of the power cord to the rear of the
HJ500P in the corresponding receptacle.
2. Plug the other end into a 115 Volt AC, 60 Hz.
Grounded outlet.
Connecting to the Computer
Plug the parallel printer cable from your computer into the
rear of the printer and latch the two locking clips.
The cable
used to connect the HJ500P to the computer must not
exceed 6 feet long.
NOTE: The parallel port may be used for all versions of
Windows. The USB port is used only for Windows ME, 2000,
and XP.
Do not use an adapter plug or extension cord to
connect the printer to the wall receptacle.
Do not use outlets controlled by wall switches.
Do not use an outlet that shares the same circuit
with large electrical machines or appliances
.