198
User Manual Version 3.1
Adjusting the
paper feed
ramp and the
slide
Put the feed ramp (F5) to a low and centered position. Insert a small
stack of paper as shown in Figure 5.
•
Loosen the fixing screw of the slide (F6), mounted on the paper
feed ramp. Raise the paper feed ramp to an appropriate angle (see
note below) and fix it..
•
Adjust the slide (F6) as shown in Figure 5. The lowermost two or
three media should fall loosely out of the stack, so they can be
easily gripped by the feed roller.
•
Tighten the fixing screw of the slide.
Angle of the paper feed ramp
The optimal angle depends on the width of your material running
through the machine:
flexible material, small width
= steep angle
inflexible material, large width = flat angle
Figure 5: Adjusting the paper feed ramp
and the slide, side view
Figure 6: Filing the stack
with a fanned out pile, side view
Filling the
paper stack
•
If not already done, fan out a small stack of products
(approximately 25 mm / 1”) and put it between the paper side
guides (F7). The fanning out ensures that the media are gripped
effectively by the feed roller (F9) and that no multiple sheets are
fed.
•
The paper stack should adapt to the shape of the fixed separation
roller (F8) (see Figure 6).
•
Fill the stack up to a convenient height for your particular medium.
Paper format, stack height
The height of the stack may be limited, due to the size of the media
and the weight of the stapled products.
Pos: 136 /Bedienungsanleitungen/Geräte spezifisch/Drucker/11_x_Ü2_Additional information texts in main display_Systeme @ 1\mod_1264070368112_912.doc @ 10550 @ 2
F5
F6
F7
F9
F8
Summary of Contents for HJ 3630
Page 26: ...26 User Manual Version 3 1...
