User Manual Version 3.1
135
8.2.12
The printed ink doesn’t dry on the substrate
Condition Problem Solution
The used ink doesn’t dry fast
enough.
The printout looks partly
smeared.
The drying time is too short.
There is too much ink on the
printout.
The material-ink combination
is not suitable.
Reduce the print quality (e.g.
2x6dpi instead of 3x6dpi) to
decrease the amount of ink.
If available, put a conveyor
behind the printer to extend
the drying time.
Reduce the transport speed
to extend the drying time.
Try another kind of ink (see
9.1.1, on page 164). Vary
the material-ink
combinations.
If available, use an infrared
light dryer (ask your local Hasler
dealer).
Pos: 97 /Bedienungsanleitungen/Geräte spezifisch/Drucker/8.2.x_Ü3_How to reset the printer @ 1\mod_1263547335243_912.doc @ 10311 @ 3
8.2.13
How to reset the printer
To reset the printer to the factory settings, you have to start the printer in a special mode.
Non-Mechanical Reset (resets all settings, except for mechanical settings):
1.
Turn off the printer
2.
Press AND hold the following key: Quick
3.
Turn on the printer
4.
Keeping holding the Quick
key until the printer shows
Non-Mechanical Reset
Alignmt Values Saved
5.
Release the Quick
key and the printer will be ready to use.
Summary of Contents for HJ 3630
Page 26: ...26 User Manual Version 3 1...
