Propeller Owner's Manual
115N
INSTALLATION AND REMOVAL
61-00-15
Page 3-18
Rev. 24 Dec/20
CAUTION:
A MINIMUM OF ONE THREAD MUST
BE COVERED BY FLAT WASHER(S)
TO MAKE SURE THE SPINNER
MOUNTING NUT WILL NOT BOTTOM
OUT ON THE NON-THREADED AREA
OF THE HUB CLAMPING BOLT. REFER
TO FIGURE 3-5 FOR ILLUSTRATIONS
OF ACCEPTABLE/UNACCEPTABLE
THREAD COVERAGE.
(3) Install one flat washer and/or spacer (if applicable) onto
the hub clamping bolts, then check the thread coverage
on the hub clamping bolts in accordance with Figure 3-4.
(a) If the washer/spacer covers a minimum of one
thread on the hub clamping bolt, go to step (4) of
this procedure.
(b) If the washer/spacer does not cover at least one
thread on the hub clamping bolt, install additional
flat washer(s) from the spinner mounting kit in
accordance with Figure 3-5.
1
Up to three flat washers can be installed in
Area 1 to get proper thread coverage.
Refer to Figure 3-4 and Figure 3-5.
