NetXpress LX & CM-30 Installation & Operation Manual
4 – Configuration & Operation
Version 1, September 2010
4-52
Harris Corporation
Intraplex Products
Figure 4-51. Stream Creation – Stage 3: IP Config for All Streams (for Multi-Unicast)
Stream Name:
The unique name entered in Stage 1 that describes the stream.
Multicast
or
Destination IP Address:
Type the IP address for the WAN interface of the NetXpress
LX system at the other end of this stream.
Local UDP Port:
Type the local UDP port in ingress and egress stream packets. The local UDP port
number must be a multiple of 5 between 50000 and 65535, inclusive.
Remote UDP Port:
Type the remote or peer’s UDP port for ingress and egress stream packets. The
remote UDP port number must be a multiple of 5 between 50000 and 65535, inclusive.
CoS Priority:
Click the CoS level that applies to all egress packets for the stream:
Low
,
Medium
, or
High
.
Normal
is the default.
Egress IP Pkts. TTL:
Type the value of the IP TTL (Time to Live, # of hops) to be used in egress
stream packets. The default is 64. This number is decremented once by every router that handles the
packet. Once this field reaches 0, the packet is discarded by the router and does not reach any other
systems.
Cancel:
Click this button to return to the
Streams
Table
page without creating a new stream.
Prev:
Click this button to return to the
Stream
Creation
–
Stage
2
page.
Next:
After completing the
Stream
Creation
–
Stage
3
page
, click this button to advance to the
Stream
Creation
– Stage
4
page (Figure 4-52).
Note:
For multi-unicast streams, remember to click each stream tab and configure the stream
parameters on the corresponding page before going to the
Stream Creation – Stage 4
page.
