NetXpress LX & CM-30 Installation & Operation Manual
4 – Configuration & Operation
Version 1, September 2010
4-44
Harris Corporation
Intraplex Products
Reset:
Click this button to reverse all changes to this page.
Submit:
Click this button to save and apply all changes to this page.
Note:
Although the system can assign TOS to traffic leaving the NetXpress LX system, the
effectiveness of tagging packets with TOS/COS depends solely on support from the routers
within the IP network.
4.3.4.4
SNMP Configuration
Use the
SNMP
Configuration
page (Figure 4-43) to establish and manage the Simple Network
Management Protocol (SNMP) event host configuration for Hosts 1 and 2. An SNMP community is a
group of hosts that you can manage as a distinct group with SNMP. The SNMP communities group
contains a list of community/IP address pairs identifying those management stations from which the
agent on the local host accepts queries. Along with each pair is an access field that controls whether
access is allowed, and if so, whether the access granted is read-only or read-write. In addition, the
special community public, with an address of 0.0.0.0, restricts or allows access to all other members
of the public community. To access this page, point to
Networking
and click
SNMP
.
Figure 4-43. Networking | SNMP Configuration
Refresh:
Click to manually refresh the browser.
SNMP Communities
Read-Only community name:
The SNMP
community name a SNMP manager must use to read an
element of the NetXpress LX MIB.
Read-Write community name:
The SNMP
community name a SNMP manager must use to modify
an element of the NetXpress LX MIB.
Enable traps on authentication failures:
Click this check box to initiate traps for failed logon
attempts.
