4 – Configuration & Operation
NetXpress LX & CM-30 Installation & Operation Manual
Version 1, September 2010
Harris Corporation
4-73
Intraplex Products
Subnet mask:
Type a subnet mask address for this IP address.
Close:
Click this button to return to the
IP
Access
List
page without creating an entry or after
creating an entry.
Add Address:
Click this button to create an address entry within the
IP
Access
List
.
4.3.8 Send Echo Requests
You can send echo requests to a host IP address using the
PING
Utility
page
(Figure 4-69). To access this page, point to
Utilities
and click
Ping
.
Figure 4-69. Ping Utility
Host IP Address:
Type the target (Host IP address) for the ping request.
Don’t Route Past Local Network:
Select this check box to limit the ping request to the local subnet
only.
Number of Packets:
Type a number of echo requests (packet ping requests) to be sent or click the
arrows to increase or decrease the displayed number. The default value is
1
.
PING Result:
The result of the ping request (
Got
Response
or
No
Response
).
Send Ping:
Click this button to execute the ping request.
4.3.9 Configure CM-30 Module
On the
Home
page of the
NetXpress LX
interface, click
Open
on the
CM-30
module to access these
configuration pages:
●
General
●
Revisions
●
Program Boot ROM
Click a tab to access that page.
4.3.9.1 CM-30 General Configuration
The
General
configuration page (Figure 4-70) allows you to view information for the CM-30 module
(such as IP and MAC addresses, serial number, and insertion date) and modify the board description.
