12
3-90-00674R20_08/12
Installation
5.
The power cord can be installed exiting the left
(standard) or right side of the surround. If a right side
cord is desired, follow the instructions below.
The cord is located on the left side, standard from
Harman. (See fig 21.)
To route the cord to the right side:
• Cut the wire-ties looping the cord to the left
• Re-route the cord along the top of the steel angle and
down the right side.
• Re-tie (not supplied by Harman) the wire through the
notches provided in the mounting frame. Then down
the right side rail.
• Do not remove or move the cord retainer, it is made
to reach both the right and left sides.
Nothing can extend
beyond this face to
the back side.
dO
NOT
CuT.
With the three wing pieces completed, the cord retainer
must be bolted to the bottom rear of the wing. Either
left exit (shown in fig. 22) or right exit.
At the bottom rear edge of the right and left wing there
is a small radius indent for the cord to exit between the
wing and the fireplace face.
6.
You must now decide whether to install the room
sensor as a wall sensor or as a return air sensor.
Harman highly recommends that the room sensor be
installed. If you are installing the room sensor as a wall
sensor, the long black 2 wire cable must be wire-tied to
the power cord. This wire is long enough to reach the
end of the power cord so the installer can reach past
the hearth to the location where the extension wire (18/2
thermostat wire, not supplied by Harman) can be spliced
to go to the wall location chosen for the room sensor.
Fig. 21
Fig. 22
The optional wing extension is made for fireplace
openings which are larger than the cast wing. The
standard wing extension is 48" wide by 34" high.
Custom sized wing extensions can be purchased from
your dealer, for any fireplace openings larger than the
standard wing extension area.
These optional wing extensions will have a 1/2 inch
return bend as shown in fig. 20. Custom oversized
wing extensions with a radius top can be ordered with a
radius of your choosing. These radius wing extensions
WILL NOT have a return bend, although they will be
made of thicker metal to reduce warpage.
(5/32" allen wrench)
Optional wing Extension
Changing the cord exit location from the left side
to the right side:
Fig. 20
1/4-20 x 3/8
button head bolts
(5/32" allen
wrench)
Connecting the cord retainer to the wing
ground
wire-ties
Fig. 23