10
3-90-00674R20_08/12
Installation
how to reduce the weight for Installation, cont'd
• Lift up on the 2 bottom corners of the medallion until
it is higher than the top of the flame guide.
• Pull the bottom edge of the medallion front approximately
1 inch.
• Pull downward on the corners of the medallion until
the top is released from the 2 retainers that keep the
top aligned when in place.
• Note: The heat exchanger covers will tilt to the front
when the center medallion is removed.
l
• Remove the heat exchanger cover by lifting it upward
about 1/2 inch and move the bottom edge front until it
sits flat on the firebox bottom.
• Rotate the edge of the heat exchanger closest to the
burnpot until it is in front of the burnpot.
• Tip the top of the heat exchanger toward the middle
of the opening until it can be lifted up and out.
Center medallion
Flame guide
burn Pot
3
rd
: dOwN
3
rd
: dOwN
1
st
:uP
2
nd
: OuT
2
nd
: OuT
1
st
:uP
Fig. 14
lifting tab
Fig. 15
Remove the cast side panels by lifting them upward off
of the hinge pins. See Fig. 13.
removing the Center medallion
removing the heat Exchanger Covers
Lasered hinge pin
pivoting point
Up and down clearance
adjustment slots.
Cast side
panel hinge
Fig. 13
2. Remove the door by swinging it open approximately
90
o
and lift it upward until it clears the hinge pins.
3. Remove the ash pan
4. Remove the (4) internal pieces of cast iron. See Fig.
14 and 15.