11
3-90-00674R20_08/12
Installation
ImPOrTANT:
The mounting frame/surround
assembly and flue piping is the most critical part of the
installation and must be done correctly and installed
securely.
1
. Choose the chimney configuration that is best
suited for the installation. See venting section. Page
21
• Note: If 100% outside air is desired or required,
the outside air option will need to be installed on the
stoves body. (See instructions included with outside
air kit (part #1-00-674080.) See Page 22.
2.
Make sure the unit will fit into the fireplace
opening. When installing in smaller fireplaces, test
fit the mounting frame into the firebox. Note: The unit
overhangs to the rear. See Fig. 17
3.
Install the 3 piece cast surround set to the sides
and top of the mounting frame with the bolts and
nuts supplied. The left and right side should be done
before the center section is installed. Make sure the
bolts are loose. Do not remove the side panel hinges.
The left and right side wings should be standing up
aligned with the side of the mounting frame and slid
inward towards the center. Note:The wings mount on
the rear side below the notch and on the front side
above the notch. See Fig. 16 & 18. Slide the cast ash
lip onto the frame and check to make sure it can go
against the roped frame rails and fits into the pockets
on the left and right cast sides. See Fig. 19.
Install the center section.
4.
If the wing extension is required, it should be
installed next.
beginning Installation
NOTE: The stove body extends through the mounting
frame in the rear approximately 2".
Approximately 2" overhang
Fig. 17
Cast in front of
the frame. Use
(1)1/4-20 x 3/8
flange bolt from
the rear.
Cast behind the
mounting frame
flange. Use (2)
1/4-20x5/8 flange
bolts and nuts
with bolts from
the front.
Fig. 18
Slide the ash lip
casting into the
frame, making
certain the ash
lip is sitting on
the slide rails on
either side. With
the ash lip in
place, adjust the
surround sides so
there is an even
gap where the
ash lip extends
into the surround
side and tighten.
Fig. 19
3" Outside Air
starter collar
Fig. 16
Notch
Ash lip slide rails