18
Setting Up the Receiver
EZ Set/EQ:
the BDS receiver’s eZSet/eQ™ system uses the supplied ezSet/eQ
microphone to perform this important step automatically. Before beginning, be sure you
have correctly connected your speakers to the BDS receiver.
IMPORTANT: Press the
remote’s “Disc” input button before performing the EZ Set/EQ procedure. The EZ
Set/EQ procedure is only available when the Disc input is selected.
1. plug the supplied ezSet/eQ microphone into the BDS receiver’s Headphone connector.
2. place the microphone at ear height in your main listening position.
3. press the remote control’s Home button. the receiver’s Home Menu screen will
appear on the tV.
1 / 5
Exit
Option
Type: Settings
Home Menu
Blu-ray Disc
FM Radio
HDMI input
Component input
Playlist
Settings
OPTIONS
HOME
4. use the cursor and ok buttons to highlight and select Settings. the general Settings
menu will appear.
Select to adjust general settings
System
Language
Playback
Parental Control
Network
General Settings
5. use the right cursor button to select audio Settings, then use the down cursor button
to select Speaker Settings. the Speaker Settings screen will appear.
Select to adjust speaker settings
Tone Controls
Audio Output
Speaker Settings
EzSet/EQ
Manual Configuration
2.0
2.0
Audio Settings
6. press the right cursor button to select ezSet/eQ, then use the cursor buttons to
select the configuration of your speaker system.
The EzSet/EQ automatic setup can calibrate the BDS system and configure the
loudspeakers parameters automatically to get the best sound performance.
Tone Controls
Audio Output
Speaker Settings
EzSet/EQ
Manual Configuration
Off
2.0
2.1
3.1
5.1
Audio Settings
7. press the ok button, then press it again to select continue in the ezSet/eQ (automatic
Setup) box that appears.
The EzSet/EQ automatic setup can calibrate the BDS system and configure the
loudspeakers parameters automatically to get the best sound performance.
Tone Controls
Audio Output
Speaker Settings
EzSet/EQ
Manual Configuration
Off
2.0
2.1
3.1
5.1
Audio Settings
EzSet/EQ(Automatic Setup)
Please plug the microphone into the system and
then place it at ear level at your desired listening
position. If a Subwoofer is connected, set the level
control (on the Sub) to half.
Continue
Cancel
8. remain silent while the test noise plays through the speakers. as the test noise
circulates among the speakers the screen will show which speaker is being tested.
The current testing speaker is L
EzSet/EQ(Automatic Setup)
Testing...
Please keep room silent.
SUB
L
LS
RS
R
C
Audio Settings
9. When the testing process is completed, the “testing...” message on the screen will
change to “all test done!”
10. press the clear/exit button to exit the ezSet/eQ test procedure.
note: If the test fails, the “testing...” message on the screen will change to “test failed,
please make sure the speaker is connected correctly and room is silent, then retest.”
press the clear/exit button, make sure all speakers are correctly connected and perform
the test again from Step 6. Make sure that the room remains silent during the test.
BDS 270/BDS 570
