![Hardi NAVIGATOR FORCE Instruction Book Download Page 82](http://html.mh-extra.com/html/hardi/navigator-force/navigator-force_instruction-book_597254082.webp)
6 - Maintenance
82
250 Hours Service - Inspect Parking Brake (optional)
Inspect the following:
Parking brake lever
If it can be pulled further backwards than 90° (midway), using a traction
of approximately 25 kg, the cable needs to be adjusted.
Parking brake cable
Inspect the parking brake cables for possible wear or damages. Replace
worn or damaged parts.
When the parking brake is relieved, the cable must be limp; otherwise it
needs to be adjusted.
Correct length:
•
When the brake is relieved, the cable must be tight and yet not
stretched.
•
Lengthening/shortening of the parking brake cable is carried out
by adjusting the turnbuckle located inside the frame.
μ
ATTENTION! There are two versions of the hand brake system
available. One version is connected to the centre of the wheel
axle (see picture to the right), the other version is connected near
the wheel.
1.
Once the brake lever (A) is adjusted, tighten the cable by moving the hand brake lever (B) back.
2.
Tighten the bolts on the brake connector (C).
3.
Fine-tuning of the hand brake can be adjusted with the cable bolt (D).
250 Hours Service - Brake Adjustment (optional)
Lift the back of the sprayer from the ground. It is recommended to use
two lifting jacks, which are placed under the wheel axle. Make sure the
sprayer is stable and secured before carrying out any adjustments.
μ
ATTENTION! There are two versions of the hand brake system
available, one of the pictures should show your system at hand.
1.
Loosen the 4 bolts at the brake connector (C) between the brake
arms. Also loosen the screw in each end of the brake connector
and the hand brake cable.
2.
Adjust the nut (A) counterclockwise. Turn the nut 60° (1/6 turn) at a time - alternately on both left and right brake.
Continue the adjustment, until resistance occurs when rotating the hub/wheel.
3.
Turn the nut 60° (1/6 turn) clockwise to loosen brake. Hub/wheel
should rotate freely now.
4.
Tighten the brake connector (C) bolts again.
5.
Tighten the hand brake cable again - See “250 Hours Service -
Inspect Parking Brake (optional)” on page 82.
±
WARNING! The adjustment must be carried out simultaneously
on both brakes. Therefore, adjust both left brake and right brake
alternately.
Summary of Contents for NAVIGATOR FORCE
