HARD Stockton N1035P, Instructions For The Assembly

Page: 12 / 16

Continued on next page...
INSTALLATION OF HEAVY DUTY BUMPER PADS
You should have 4 pads. 2 are square shaped
and identical. They are used on the headboard
and footboard.
The other 2 pads are long and rectangular
shaped for the side rails and are “side
speci
fi c”. There is a tag on both side pads,
and each marked “left” or “right” The left or
right side of the bed is determind by standing
at the foot end of the bed where the crank
handles or electric sta
ff
control are.
The pads should be installed without the mattress in place.
Place 1 square shaped pad against the inside surface of the headboard with the 2
white strings hanging down to the corner brackets of the spring assembly. (The corner
brackets are the areas where the mattress platform attaches to the legs of the bed)
Put the vinyl fl ap with the Velcro over the top edge of the headboard and a
ffi
x it to the
outside face of the headboard. This secures the top of the bumper pad.
Tie o
ff
both white strings to the corner brackets of the mattress platform. A “shoelace
bow” will su
ffi
ce. This secures the bottom of the bumper pad.
Repeat these procedures for the other square shaped bumper pad for the footboard.
INSTALLING PADS ON THE HEADBOARD AND FOOTBOARD