HARD Stockton N1035P, Instructions For The Assembly

Page: 13 / 16

INSTALLATION OF HEAVY DUTY BUMPER PADS- CONT.
There are white elastic straps with clips on the ends hanging from the bottom of the side pads.
Wrap this elastic band around the beam of the lower frame assembly as shown, and clip it to
itself to tie it o
ff
. Tie o
ff
the 2 white strings on the ends of the side pads to the corner brackets
with a shoelace bow in the same manner the end pads were done.
The 3 vinyl fl aps go over the top edge of the side rail and a
ffi
x to the outside face of the side
rail. Be careful not to cover the 2 openings for the fi ngertip trigger assembly mechanisms.
With the side rail in highest position and locked in place, place one of the pads along the inside
face of the side rail with the elastic straps and white strings towards the
fl oor.
**IMPORTANT** - The triangle shaped area on the pad (the area that doesn’t have any padding)
must go towards the head end of the bed. This triangle shaped area allows the head end of
the bed to be elevated without bunching up and interfering with the bumper pad.
INSTALLING PADS ON THE SIDERAILS
Head End
Installation of pads is complete. Mattress can
be installed/re-installed at this time.
Continued on next page...