For technical questions, please call 1-888-866-5797
13
ENHANCED DTCs (FORD / MAZDA ONLY)
Using the Scan Tool
VIEWING OEM ENHANCED DTCs (Ford/Mazda only)
13
Turn the ignition OFF, then back ON. Press
ENTER
.
Proceed to step
3
.
3.
A “One moment please” message displays while the test is in progress.
If the Scan Tool fails to link to the vehicle’s computer, a
“Communication Error” message shows.
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press
LINK
to continue.
If the Scan Tool
cannot
link to the vehicle’s computer after three
attempts, the message “Contact Technical Support” displays.
- Press
SYSTEM MENU
to return to the System Menu.
- Turn the ignition off, and disconnect the Scan Tool.
- Contact Technical Support for assistance.
If the
KOER
Test was selected, and the vehicle’s engine
is not
running, an advisory message shows.
- Start the engine and press
ENTER
to try again, or, press
SYSTEM MENU
to return to the System Menu.
If the
KOEO
Test was selected, and the vehicle’s engine
is
running
, an advisory message shows.
- Turn the ignition OFF then back ON and press
ENTER
to
try again, or, press the
SYSTEM MENU
button to return to
the System Menu.
4.
If the
KOER
test was selected, an “instructional” message shows.
Turn the steering wheel to the left, then release.
Press and release the brake pedal.
Cycle the overdrive switch (if equipped).
A “One moment please” message displays while the test is in
progress.
5.
Refer to DISPLAY FUNCTIONS on page 2 for a description of LCD
display elements.
I/M MONITOR STATUS icons
are not displayed when
viewing enhanced DTCs.
In the case of long code
definitions, a small arrow is
shown in the upper/lower
right-hand corner of the code
display area to indicate the
presence
of
additional
information.