DEAR CUSTOMER
Even before we started working on this product we thought of it as a
companion piece to our previous wireless products, a sequel of sorts
- The next chapter.
We knew it had to be special so we worked hard. And then we worked
even harder. Sharing this journey with you all has been the gift of a
lifetime and I hope you can see and experience our gratitude within this
product. Thank you!
Best Regards,
Andreas Vural, founder of Happy Plugs
CONNECT AND USE
Activate Bluetooth on your phone or device.
Remove the Air 1 earbuds from the charge case, and select “Air 1 by
Happy Plugs” on your phone/device to pair. Keep the earbuds within
20 cm / 7 inches apart from each other.
Insert the Air 1 earbuds into your ears. Adjust the angle to find
your perfect fit.
When inserting the Air 1 into your ears - make sure not to
touch the touch control surface. A four second touch turns the
earbud off.
CHARGING THE CASE
Charge your Air 1 case by connecting the included Micro-USB cable to
a USB power source. When the Air 1 case LED is turned on, the case is
charging. When the light turns off your Air 1 case is fully charged.
CHARGING THE EARBUDS
To charge the Air 1 earbuds place them in the charging case. When the
Air 1 earbud LED is turned on, the earbud is charging. Once the lights
turns off you Air 1 earbud is fully charged.
LED GUIDE
The Air 1 earbuds & case LEDs are lit up while charging. When fully
charged the light turns off. When removing the Air 1 from the case, the
earbuds’ LED will blink slowly while pairing to your bluetooth source
and blink fast while connecting to each other.
CALLS
Using the Air 1 for phone calls, both earbuds are active, but only the
right (R) earbud has dual microphones. This means that you need to
use the right (R) earbud when using just one earbud for phone calls.
To get the most out of your new Air 1 when used together with an
Apple Device; while your Air 1 is paired go into Settings > General
> Accessibility, scroll down to Call Audio Routing and select
Bluetooth Headset.
TOUCH CONTROLS
Both earbuds have a touch sensor (see illustration). Tap it with your
finger to control your calls and music according to the guide.
SIRI OR GOOGLE ASSISTANT
Control your calls and music with Siri or Google Assistant by pressing
2 sec on right (R) earbud.
To use Siri on your iPhone while it is locked, go into
Settings > Touch ID & Passcode, scroll down to Allow Access
when locked and enable Siri.
RESET TO FACTORY SETTINGS
If you need to reset your earbuds and terminate any previous bluetooth
pairing:
Touch the sensors on the left (L) and right (R) earbud for 5
consecutive seconds until they turn off.
Touch the sensors on the left (L) and right (R) earbud for 10
consecutive seconds until there is an audio signal in each earbud.
The LEDs will turn off at this stage.
Place your earbuds in the Air 1 case until the LEDs turns on.
Take the earbuds out of the Air 1 case to initiate the pairing between
left (L) and right (R) earbud. Keep the earbuds within
20 cm / 7 inches apart from each other.
HAPPY PLUGS AIR 1 USER MANUAL
FULL INSTRUCTIONS & FAQ AVAILABLE AT:
HELP.HAPPYPLUGS.COM
