Hanwha Techwin Wisenet SPD-152, Manual

Page: 29 / 66

English
_29
•
l
IVE
live
•
l
IVE
Dewarping
You can correct distorted images from the fisheye camera.
Select the desired channel and click <
>.
You will enter the setup mode for dewarping.
￭
This function is not supported in some models.
￭
This works only when the video resolution is 1:1.
￭
The set dewarping mode is cleared when the layout is changed, so set it again.
￭
Dewarping will be applied only to the selected channel.
￭
In dewarping mode, the frame rate of the video is limited depending on the resolution. (3 fps - 30 fps)
●
: Dewarping mode is closed.
●
: You can select from among <
Single
>, <
Quad view
>, <
Single panorama
>, and <
Double panorama
> for
the view mode.
– Single, Quad view: You can use the PTZ function by dragging the mouse up, down, left, and right or by using
the mouse wheel.
– Single panorama: You can select this when the mounting mode is < Wall >.
– Double panorama: You can select this when the mounting mode is < ground > or < Ceiling >.
You can use the PAN function by dragging the mouse left and right.
●
: You can select the mounting mode from
<ground>
,
<Wall>
, and
<Ceiling>
.
pTz CONTROl
With this decoder, you can configure the settings of PTZ cameras aside from general security cameras to users'
preferences.
This is active only if a channel that a PTZ camera is connected to is selected.
getting Started with pTz Operations
The PTZ camera will be activated only if the channel of the PTZ camera is selected. After selecting the desired
channel, click < > on the live screen menu.
￭
This is available only if a PTZ camera is connected and the < > icon is displayed on the screen.
￭
Even if the connected network camera does not support the PTZ operations, you can configure the PTZ control settings (if possible) by installing
the PTZ driver (physical device).
￭
It only supports a network camera with Hanwha Techwin's PTZ function and a camera registered in the ONVIF.
pTz Control menu
You can use a single camera to perform the Pan, Tilt, and Zoom operations to monitor multiple places, and
configure the custom settings of the presets in the desired mode.
Click <
pTz control
> on the bottom left of the Live screen to display the PTZ camera control menu as shown
below.