Hanwha Techwin Wisenet SPD-152, Manual

Page: 13 / 66

English
_13
•
g
ET
TIN
g
ST
ARTED
getting started
•
g
ET
TIN
g
ST
ARTED
INSTAllATION WIzARD
As shown below, proceed through each step of the < Installation wizard >.
Installation Wizard can only be accessed at factory default status. If you do not want to proceed, click < Exit >.
￭
It will automatically change to the optimal monitor resolution and run the installation wizard.
￭
If the installation wizard does not run, remove the monitor connection from the back of the decoder, reboot the decoder and reconnect the monitor.
1. On the < language > screen, select the language and press the < Next > button.
2. Set the network connection type and the connection environment on the < Network > screen, and then click the
< Next > button.
Setting up the Network
●
Network (All): Can be used as a common port for the camera and web viewer connection.
●
Setup
– IP type: Allows you to select the type of network access.
– IP address, Subnet mask, Gateway, DNS
￭
Manual: The IP address, subnet mask, gateway, and DNS can be entered manually.
￭
DHCP: The IP address, subnet mask, gateway, and DNS can be automatically set.
Online Upgrade
You can receive new firmware notifications when the decoder connects to a network.
SETTINg ThE SySTEm OpERATION mODE
If you have admin permissions, you can select operation mode to control the decoder.
1.
Select < > at the top right of the screen.
2. The < Operation mode > settings window will appear.
3. After selecting the desired operation mode, click < Change >.
●
Standalone: Can control Live monitoring and changes to the settings of the camera on a decoder.
You can only change admin account information and operation mode in the web viewer.
●
WEB: Can only Live monitor the camera on a decoder, and you need a web viewer to change the settings or
control.
4. If you change the operation mode, the decoder restarts and the set layout is initialized.