Hangar 9 HAN5065, Instruction Manual

Page: 24 / 100

24 EN
13.
14.
15.
16.
17.
14. Position the fuel tank on the tray, guiding the fuel tubes
through the opening in the fi rewall. Use the hook and loop
straps to secure the fuel tank to the fuel tank tray.
15. Connect the fuel line from the clunk to the carburetor.
Make sure to install the fuel fi lter included with your
engine, securing the tubing to each fi tting using tie wraps
or wire ties.
16. Wrap the ignition module using 1/2-inch (13mm) foam
rubber. This will keep it from moving inside the fuselage
when the engine has been installed. Place the module
in the fuselage. Guide the wires to the receiver into the
fuselage, and the spark plug and sensor leads forward
out of the fuselage.
17. Position the engine assembly near the fuselage. The
sensor lead and spark plug wire will fi t through the
opening in the fi rewall. Connect and secure the sensor
lead.
13. Secure three 140mm pieces of fuel tubing to the tubes of
the stopper. Note the position of each tube so they can be
connected when the tank is installed in the fuselage.
18.
19.
20.
21.
19. Thread a clevis on the throttle pushrod. Guide the pushrod
through the hole in the fi rewall made earlier. Bend the
pushrod as necessary to it lines up with the hole, and will
clear the muffl e when it is installed later in this manual.
20. Mount the throttle servo in the fuselage. Position the
servo as close to the fuel tank as possible with the servo
output facing the rear of the fuselage.
21. Use a pushrod connector (not included) to connect the
throttle linkage to the servo. Use side cutters to remove
any excess wire that may interfere with the operation of
the servo. Check that the carburetor moves from fully
open to fully closed using the radio system.
18. Carefully fi t the engine assembly into the fuselage. Guide
the leads through the fi rewall, and keep the ignition
module above the fuel tank. Once positioned, secure
the engine assembly to the fuselage using four M4 x 30
machine screws and four M4 washers. Make sure to
use threadlock on all the screws to prevent them from
vibrating loose.