Hangar 9 HAN5065, Instruction Manual

Page: 22 / 100

22 EN
4. Attach the motor box to the fuselage using four M4 x 20
socket head cap screws and four M4 washers. Apply
threadlock to the screws before tightening them using a
#2 Phillips screwdriver.
Î
Secure a 12-inch (300mm) servo extension
to connect the speed control to the receiver.
5. The speed control is attached to the side of the motor box
using hook and loop tape (not included) and tie wraps (not
included). Secure the switch so it does not interfere with
the operation of the model.
Î
It may be necessary to change the connectors
on the speed control to match the battery.
3. Thread the blind nuts included with the motor onto the
screws with the prongs facing toward the wood. Apply
threadlock to the screws and tighten them using a 2.5mm
hex wrench.
8.
9.
10.
8. Place hook and loop tape on the battery tray to keep the
battery from sliding inside the fuselage. The front of the
battery tray is angled to match the thrust built into the
fi rewall. Make sure to apply the hook and loop tape to the
top of the tray.
10. Fit the battery tray into the fuselage. The tabs at the front
of the tray will fi t into notches in the back of the fi rewall.
Secure the battery tray using an M3 x 12 socket head cap
screw and M3 washer. Tighten the screw using a 2.5mm
hex wrench.
9. Secure the battery to the battery tray using hook and
loop straps. The position of the battery can be adjusted to
achieve the correct balance point for your model.
1.
2. 2. Remove the template from the fi rewall. Use a 3/16-inch
(4.5mm) drill bit to enlarge the pilot holes in the fi rewall.
1. Use tape to secure the template to the fi rewall. Use a drill
and 1/16-inch (1.5mm) drill bit to drill the pilot holes for
the engine mount into the fi rewall.
‰
GAS ENGINE INSTALLATION 6. Secure the wiring so it won’t interfere with the operation
of the motor or the installation of the battery.
Î
Secure a 6-inch (150mm) EC3 extension to
connect the speed control to the battery.
Î
It may be necessary to change the connectors
on the motor to match the speed control.
7. Place hook and loop tape on the battery to keep the
battery from sliding inside the fuselage.
Î
Do not cover safety warnings on the
battery with hook and loop tape.
3.
4.
5.
6.
7.