21
EN
Carbon Cub 15cc
6.
7.
8.
9.
10.
7.
Slide the M4 wheel collar to the axle. Secure the wheel
collar 1/4 inch (6mm) from the end of the axle using the
M3 setscrew and a 1.5mm hex wrench. Use threadlock
on all metal-to-metal fasteners to prevent them from
vibrating loose.
8.
Apply a drop of light machine oil to the axle. Slide the
outer end of the axle into the wheel hub. Fit the hube into
the wheel.
9.
Fit a second wheel hub into the wheel over the axle.
10.
Assemble the wheel by inserting the four M3 x 25
machine screws through the hub from the outside of the
wheel.
6.
Attach the strut assembly to the main gear and the cross
brace. Use the two M3 x 12 socket head cap screws at
the center, and the M3 x 15 socket head cap screws near
the wheels. The screws are secured using M3 locknut,
and tightened using a 2.5mm hex wrench and 5.5mm nut
driver.
11.
12.
13.
12.
Attach the hub cap to the wheel using a small amount of
silicone adhesive.
13.
Slide the axle into the main gear. Secure it using the M4 x
6 setscrew, tightening the setscrew on the fl at of the axle.
Use a 2mm hex wrench and threadlock when installing
the setscrew. Use threadlock on all metal-to-metal
fasteners to prevent them from vibrating loose.
11.
Use four M3 nuts to secure the wheel hubs together.
Make sure the wheel can rotate freely on the axle. Use a
#2 Phillips screwdriver and 5.5mm nut driver to tighten
the hardware. Use threadlock on all metal-to-metal
fasteners to prevent them from vibrating loose.
1.
Use a #2 Phillips screwdriver and threadlock to attach the
X-mount to the motor. Use threadlock on all metal-to-
metal fasteners to prevent them from vibrating loose.
1.
2.
2.
Insert the screws included with the motor through the
holes of the X-mount and into the holes on the motor box.
MOTOR AND BATTERY INSTALLATION
Summary of Contents for HAN5065
Page 98: ...98...
Page 99: ...99 Carbon Cub 15cc...
