HQ Infinity User Manual
| 31
To wind the bobbin
The Infinity comes with a separate bobbin winder. For full instructions about using the bobbin winder, see
the instruction manual that was packaged with the bobbin winder.
ONLINE: For more information about using the bobbin winder, watch the video Using the Bobbin
Winder at: http://www.handiquilter.com/videos/hq-infinity/245/.
To insert the bobbin into the bobbin case
ONLINE: For more information about inserting the bobbin into the bobbin case, watch the video
Inserting the Bobbin at: http://www.handiquilter.com/videos/hq-infinity/225/.
U
CAUTION: To prevent personal injury always turn off the front power switch while inserting and/or
removing bobbin case or anytime your hands are near the needle area, such as when you change
t h e n e e d l e .
1 . Place the bobbin in the bobbin case so that the
thread pulls off clockwise when viewing the
open side.
2 . Slide the thread through the slot and under the
tension spring, leaving approximately five to six
i n c h e s o f t h r e ad h an g i n g l o o s e .
To test bobbin tension
The bobbin tension is the foundation tension for the entire machine. Always set the bobbin tension first.
NOTE: Check the bobbin tension each time a new bobbin is inserted.
ONLINE: For more information about testing and adjusting the bobbin tension, watch the video
Testing and Adjusting Bobbin Tension at: http://www.handiquilter.com/videos/hq-infinity/248/.
1 . With the bobbin properly in the bobbin case, hold the bobbin case in the palm of your hand with the
open end facing up.
2 . Wrap the thread two to three around the index finger of the opposite hand and lift the bobbin up. The
bobbin case should lift up on its side, and slightly lift out of your hand. If the bobbin will not lift up on
its side, the bobbin tension is too loose and if it lifts out of your hand, the bobbin tension is too tight.
