HandHeld SV series, User Manual

Page: 64 / 104

6 - 20 Quick Check® SV Series User’s Guide
Value of action- aaa
~PLpii
List all Port setup parameters. (Parameters are set by the ~PB command.)
pii= Three decimal digits representing:
Port- p
ID- ii
~PT#
Show <Port 1 to 8> status and all the Port Parameters (Parameters are set by the
~PB command.)
Transmission is in the following format for command ~PT1:
1. ~PT
2. hexadecimal value ‘4’ - identifies the beginning of the data packet
response.
3. A list of text strings like the one shown in the example. Each string is
terminated by a two character sequence: ‘\r’ (the carriage return character),
‘\n’ (the line feed character).
4. hexadecimal value ‘5’ - identifies the end of the data packet response
5. 1
Example return using ScanView:
Port Status:
Global HW: 001
Global SW MIRR: 001
Table of Action Parameters
IDs Description Low Value High Value
01 Pulse width (0.1s to
10.0s; > 10.0= latch) 000 255
02 Active State high or
low 000 (active
low) 001
03 Set port on Good/
Bad Evaluation 000(Bad) 001(Good)