Quick Check® SV Series User’s Guide
6 - 17
Second # - Possible values are ‘1’ (on), ‘0’ (off).
~OS#
Set Transmission Data Format
This command is effective only if the standard transmission mode is enabled via
the ~HQ0 command.
0 = Standard transmission format as described in the Serial Port Transmission
Format Section
1 =Standard transmission format modified; analysis parameters a through N
included, but encoded data is formatted as data characters only rather than all
symbol characters. The data consists only of printable ASCII characters and
does not include any mandatory symbol characters such as stop, start and
symbol mod check characters. One exception is in UPC/EAN codes, the mod 10
check digit is included.
Output Port Setup Commands - P
A ’~’ immediately followed by a ‘P’ specifies a command from the Output Port
Setup category.
Note: The following descriptions of the ~PB and ~PP commands imply all ports
are individually programmable. All SV port logic is currently programmed
via the Output Interface Mode command ~LV##. See
"Output Interface
Modes Descriptions" on page 6-24
for details of port logic. The ~PB and
~PP commands are used to program activation parameters available in
the mode settings and are limited to the case where the value of the
variable p in the command is always a value of 8. “Port 8” is a general
port used for internal purposes. This structure reserves individual port
programming to be available in the future.
Many of the activation parameters are ANSI method calculations. Please see the
"ANSI Parameter Grade Thresholds" on page 7-1
for details on the values of
these parameters.
~PBpiiaaabbb
Port barcode decision block parameters.
piiaaabbb = Nine decimal digits representing:
Port- p
ID- ii (See
"Table of Analysis Parameters" on page 6-18
for ID descriptions)
Low passing threshold- A (aaa)
High passing threshold- B (bbb)
Values for aaa and bbb can be found in the following table:
Values “A” and “B” determine the passing thresholds. If the measured parameter
is less than A or greater than B the relevant error flag would be set.
Summary of Contents for SV series
