Hand Held Products 2020, User Manual

Page: 88 / 280

4 - 8 2020/4820/4820 i User’s Guide
Streaming Presentation ™ Mode
Note: Streaming presentation mode applies only to units with advanced
illumination. Units with advanced illumination have a software revision of
31205481-036 or newer. Refer to the
Show Software Revision on page
11-2 for information on determining the engine in your unit.
When in Streaming Presentation mode, the imager leaves the scan illumination
on all the time and continuously searches for bar codes.
When using Preferred Symbology (page 4-14), a lower priority symbol must be
centered on the aiming pattern to be read in Streaming Presentation Mode.
Hands Free Time-Out
The Scan Stand and Presentation Modes are referred to as “hands free” modes.
If the image scanner’s trigger is pulled when using a hands free mode, the image
scanner changes to manual trigger mode. You can set the time the image
scanner should remain in manual trigger mode by setting the Hands Free Time-
Out. Once the time-out value is reached, (if there have been no further trigger
pulls) the image scanner reverts to the original hands free mode.
Scan the Hands Free Time-Out barcode, then scan the time-out duration (from
0-300,000 milliseconds) from the inside back cover, and
Save
.
Default = 5,000
ms.
Reread Delay
This sets the time period before the image scanner can read the same barcode
a second time. Setting a reread delay protects against accidental rereads of the
same barcode. Longer delays are effective in minimizing accidental rereads.
Use shorter delays in applications where repetitive barcode scanning is required.
Default = Medium.
Streaming Presentation Mode
Hands Free Time-Out